Verifying The Service Engine Configuration - Cisco ASR 1000 Series Software Configuration Manual

Verifying the Service Engine Configuration

• You can use the Shutdown button located on the left side of the faceplate. Use the tip of a pen or other
Once the shutdown operation is initiated by either method, the SYS LED starts to blink (green) to indicate
the shutdown operation is in progress. Once the shutdown operation is completed, the SYS LED turns off to
show that the SPA can now be removed.
Caution Make sure to wait until the SYS LED turns off before removing the SPA.
The following example shows the use of the hw-module subslot stop command:
Router# hw-module subslot 0/0 stop
ASR1004#
*Feb 18 12:37:32.260:%SPA_OIR-6-OFFLINECARD: SPA (SPA-WMA-K9) offline in subslot 0/0
*Feb 18 12:37:32.260:%ASR1000_OIR-6-SOFT_STOPSPA: SPA(SPA-WMA-K9) stopped in subslot 0/0,
interfaces disabled
ASR1004# show platform
Chassis type: ASR1004
Slot
--------- ------------------- --------------------- -----------------
0
0/0
0/1
R0
F0
P0
P1
Slot
--------- ------------------- ---------------------------------------
0
R0
F0
Verifying the Service Engine Configuration
There are several commands that provide current information and status of the Cisco WebEx Node SPA,
service engine, and other components.
Showing Cisco WebEx Node SPA Settings and Activity
You can use the show interfaces service-engine command to display Cisco WebEx Node SPA configuration
settings and current activity. After configuration, make sure that the service-engine interface is "up" and the
line protocol is "up" as shown in the following example:
Router# show interfaces service-engine
1/0/0
Service-Engine0/1/0 is up, line protocol is up
Hardware is SPA-WMA-K9, address is 001f.6c25.bd10 (bia 001f.6c25.bd10)
Internet address is 10.200.72.18/30
MTU 1500 bytes, BW 2500000 Kbit, DLY 1000 usec,
Encapsulation ARPA, loopback not set
Keepalive not supported
ARP type: ARPA, ARP Timeout 04:00:00
Last input 03:43:59, output 00:00:35, output hang never
Last clearing of "show interface" counters never
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Software Configuration Guide, Cisco IOS
XE Everest 16.5
362
Configuring the Cisco WebEx Node for the ASR 1000 Series Aggregation Services Routers
similar blunt object to press the button.
Type
ASR1000-SIP10
SPA-WMA-K9
SPA-WMA-K9
ASR1000-RP1
ASR1000-ESP10
ASR1004-PWR-AC
ASR1004-PWR-AC
CPLD Version
07091401
07062111
07051680
reliability 255/255, txload 1/255, rxload 1/255
State Insert time (ago)
ok 16:20:50
stopped 00:00:13
ok 16:18:32
ok, active 16:20:50
ok, active 16:20:50
ok 16:19:23
ok 16:19:23
Firmware Version
12.2(33r)XN2
12.2(33r)XN2
12.2(33r)XN2
OL-14127-17