Cisco ASR 1000 Series Software Configuration Manual page 493

Classifying and Scheduling Packets for the ASR 1000 Series Aggregation Services Routers
SUMMARY STEPS
1. enable
2. configure terminal
3. interface gigabitEthernet 0/0/0.1
4. plim qos input map cos inner-based
5. plim qos input map cos inner 5 6 queue strict-priority
6. plim qos input map cos outer-based
7. plim qos input map cos outer 4 queue strict-priority
DETAILED STEPS
Command or Action
Step 1
enable
Example:
Router> enable
Step 2 configure terminal
Example:
Router# configure terminal
Step 3
interface gigabitEthernet 0/0/0.1
Example:
Router(config)# interface gigabitEthernet
0/0/0.1
Step 4
plim qos input map cos inner-based
Example:
Router(config-subif)# plim qos input map cos
inner-based
Step 5
plim qos input map cos inner 5 6 queue strict-priority
Example:
Router(config-subif)# plim qos input map cos
inner 5 6 queue strict-priority
Step 6
plim qos input map cos outer-based
Example:
Router(config-subif)# plim qos input map cos
outer-based
OL-14127-17
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Software Configuration Guide, Cisco IOS XE
Configuring the Ingress Classification
Purpose
Enables privileged EXEC mode. Enter your password when
prompted.
Enters global configuration mode.
Enters the subinterface mode for Gigabit Ethernet 0/0/0.1.
Enables and allows configuration for inner VLAN COS
values.
The VLAN COS values can be enabled by default
Note
by executing the plim qos input map enable
command.
Configures the COS values or the range of the inner VLAN
of a qinq subinterface to high priority.
Enables configuration for outer VLAN COS values.
The VLAN COS values can be enabled by default
Note
by executing the command plim qos input map
enable.
Everest 16.5
447