Required Configuration Tasks - Cisco ASR 1000 Series Software Configuration Manual

Configuring the 1-Port Channelized OC-3/STM-1 SPA and 1-Port Channelized OC-12/STM-4 SPA
interface serial [slot/subslot/port ].[ds3/t1 ]:[channel-group ]
• If framing is SONET and mode is T3:
interface serial [slot/subslot/port ].[ds3 ]
SDH Mode
If the aug mapping is au-4, the au-4 value is always 1; if the aug mapping is au-3, then the only supported
mode is c-11 (carrying a T1).
• If SDH-AUG mapping is au-4 and if the tug-3 is mode t3/e3:
interface serial [slot/subslot/port ].[au-4/tug-3/tug-2/e1 ]:[channel-group ]
• If SDH-AUG mapping is au-3:
interface serial [slot/subslot/port/au-3/tug-2/t1 ]:[channel-group ]
POS on the 1-Port Channelized OC-12/STM-4 SPA
If framing is SONET and n is from 1-12:
interface pos slot/subslot/port:nsts-1

Required Configuration Tasks

This section lists the required configuration steps to configure the 1-Port Channelized OC-3/STM-1 SPA.
Some of the required configuration commands implement default values that might be appropriate for your
network.
This section includes the following topics:
Configuring the Controller for the SONET Mode and the SDH Mode
Controller configuration is required for both SONET and SDH framing modes. To configure the controller
on the 1-Port Channelized OC-3/STM-1 SPA or 1-Port Channelized OC-12/STM-4 SPA, complete the
following step:
Command
Router(config)# controller sonet slot/subslot/port
OL-14127-17
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Software Configuration Guide, Cisco IOS XE
Required Configuration Tasks
Purpose
Selects the controller to configure and enters
controller configuration mode, where:
• slot/subslot/port —Specifies the location of the
interface.
The port number is always zero on the 1-Port
Note
Channelized OC-3/STM-1 SPA and 1-Port
Channelized OC-12/STM-4 SPA.
Everest 16.5
293