Fpd Upgrade - Cisco ASR 1000 Series Software Configuration Manual

FPD Upgrade

FPD Upgrade
This section provides information if you want to upgrade FPDs for SPAs. These instructions are not always
feasible for operating network environments. If these methods of upgrade are not suitable for your situation,
see other sections of this document for other methods of upgrading FPDs.
This section contains the following topics:
Overview of FPD Images and Packages
With the Cisco ASR 1000 Series Routers, the Cisco IOS image comes bundled with the FPD image. An FPD
incompatibility on a SPA disables all interfaces on that SPA until the incompatibility is addressed.
Upgrading Your Cisco IOS Release and FPD Image
To upgrade your Cisco IOS release and your FPD image, do the following steps:
SUMMARY STEPS
1. Download the SPA package for the Cisco IOS release that you are upgrading to. The package contains
both the Cisco IOS image and the FPD image.
2. Boot the new version of Cisco IOS. When the new version of Cisco IOS boots, search for the bundled
FPD image. The FPD images will be updated automatically as part of the Cisco IOS boot process.
3. When the router has booted, verify the upgrade was successful by entering the show hw-module all fpd
command.
DETAILED STEPS
Step 1 Download the SPA package for the Cisco IOS release that you are upgrading to. The package contains both the Cisco
IOS image and the FPD image.
Step 2 Boot the new version of Cisco IOS. When the new version of Cisco IOS boots, search for the bundled FPD image. The
FPD images will be updated automatically as part of the Cisco IOS boot process.
Step 3 When the router has booted, verify the upgrade was successful by entering the show hw-module all fpd command.
What to Do Next
The time for updating the FPGA can be read in the log messages. The following is a sample for the log
message:
Jan 21 01:36:36.434: %FPD_MGMT-3-MAJOR_VER_MISMATCH: Major image version mismatch detected
with I/O FPGA (FPD ID=1) for SPA-3XOC3-ATM-V2 card in subslot 1/1. Image will need to be
upgraded from version 1.3 to at least a minimum version of 2.2. Current HW version = 1.80Jan
21 01:36:36.435: %FPD_MGMT-5-UPGRADE_ATTEMPT: Attempting to automatically upgrade the FPD
image(s) for SPA-3XOC3-ATM-V2 card in subslot 1/1. Use 'show upgrade fpd progress' command
to view the upgrade progress ...Jan 21 01:36:36.671: %FPD_MGMT-6-BUNDLE_DOWNLOAD: Downloading
FPD image bundle for SPA-3XOC3-ATM-V2 card in subslot 1/1 ...Jan 21 01:36:36.738:
%FPD_MGMT-6-UPGRADE_TIME: Estimated total FPD image upgrade time for SPA-3XOC3-ATM-V2 card
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Software Configuration Guide, Cisco IOS
XE Everest 16.5
420
Upgrading Field-Programmable Devices
OL-14127-17