Cisco Asr 1000 Series Aggregation Services Routers Sip And Spa Software Configuration Guide, Cisco Ios - Cisco ASR 1000 Series Software Configuration Manual

Configuring the Ethernet SPAs
DETAILED STEPS
Command or Action
Step 1
configure terminal
Example:
Router# configure terminal
Step 2 controller wanphy interface-path-id
Example:
Router(config)# controller wanphy 2/1/0
Step 3
wanphy flag j1 transmit string
Example:
Router(config-controller)# wanphy flag j1 transmit
passing_string_from_localend
Step 4 exit
Example:
Router(config-controller)# exit
Step 5
exit
Example:
Router(config)# exit
Step 6 show controller wanphy <interface-path-id>
Example:
Router# show controller wanphy 2/2/0
Example:
TenGigabitEthernet0/2/0
Example:
Mode of Operation: WAN Mode
Example:
SECTION
Example:
LOF = 0
OL-14127-17
LOS = 0 BIP(B1) = 0
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Software Configuration Guide, Cisco IOS XE
Configuring the Flag for Path Trace
Purpose
Enters the global configuration mode.
Enters the controller mode of the WAN-PHY SPA. In
this example, it enters slot 1 of SIP 2.
Passes the string of J1 bytes specified to the remote
end of WAN-PHY SPA.
In this example, the string value
passing_string_from_localend is transmitted to the
remotely connected WAN-PHY SPA.
Exits Controller-configuration (config) mode and enters
global configuration mode.
Exits global-configuration (config) mode and enters
privilege-exec mode.
This command must be executed on the remotely
connected SPA. The command output displays the
string of J1 byte values transmitted from the other end
of the WAN-PHY SPA to check the path.
In this example, the last line Remote J1 Byte, of the
show controller wanphy 2/2/0 command output
indicates that the string value
passing_string_from_localend has been sent from the
other end of the WAN-PHY SPA.
Everest 16.5
159