Cisco Asr 1000 Series Aggregation Services Routers Sip And Spa Software Configuration Guide, Cisco Ios - Cisco ASR 1000 Series Software Configuration Manual

Configuring the Ethernet SPAs
Command or Action
Step 6
wanphy threshold sf-ber <bit-error-rate>
Example:
Router(config-controller)# wanphy threshold sf-ber
9
Step 7
exit
Example:
Router(config-controller)# exit
Step 8 exit
Example:
Router(config)# exit
Step 9 show controllers wan <interface-path-id>
Example:
Router# show controller wan 2/2/0
Example:
Example:
TenGigabitEthernet2/2/0
Example:
Mode of Operation: WAN Mode
Example:
SECTION
Example:
LOF = 0
BIP(B1) = 13
Example:
LINE
Example:
AIS = 0
BIP(B2) = 3827
OL-14127-17
LOS = 0
RDI = 1
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Software Configuration Guide, Cisco IOS XE
Configuring WAN-PHY Signal Failure and Signal Degrade Bit Error Rates
Purpose
Sets the SF BER threshold-crossing alarm value. The
default SF BER threshold value is 10e-3. The value range
for the SF BER threshold value is 3 to 9 (10 to minus n).
In this example, the SF BER threshold value is set to 9.
Exits from the Controller mode and enters the Global
configuration mode.
Exits from the global configuration mode and enters the
Privileged EXEC mode.
The command output displays the SF, SD, BER threshold
values and B1-tca and B2-tca threshold values in the last
line of the command output in the example.
In this example, the command output shows that B1 value
is 4, B2 value is 5, SD value is 8, and SF value is 9.
FEBE = 0
Everest 16.5
167