Install And Upgrade Internal Modules And Field Replaceable Units; Replace The Chassis Covers For C111X And C1111X - Cisco C111 8P Series Hardware Installation Manual

Install and Upgrade Internal Modules and Field
Replaceable Units
The Cisco 1100 Series Integrated Services Routers have internal modules and field-replaceable units (FRUs)
that can be quickly and easily removed and replaced without having to send the entire router for repair.
This section describes how to install the internal modules and FRUs in the Cisco 1100 Series ISRs. The
information is contained in the following sections:
•
•
•
•

Replace the Chassis Covers for C111X and C1111x

To access the internal modules on the router, you must first remove the chassis cover. See the instructions
below on how to remove and later replace the chassis cover on the routers.
Warning Only trained and qualified personnel should be allowed to install, replace or service this equipment. Statement
1030
Cisco 1100 Series ISRs have removable covers. Do not run the routers with the cover off. Doing so can cause
the router to overheat very quickly.
Use a number-2 Phillips screwdriver to perform the following tasks.
Replace the Chassis Covers for C111X and C1111x, on page 59
External Modules, on page 62
Install and Remove Small Form Pluggable Modules, on page 63
Install an LTE Pluggable Module, on page 64
Hardware Installation Guide for the Cisco 1000 Series Integrated Services Router
4
C H A P T E R
59