Advertisement
QFX5200-48Y Quick Start Guide
Enable telnet service.
10.
[edit]
root@# set system services telnet
NOTE: When Telnet is enabled, you cannot log in to a QFX5200 switch through Telnet using root credentials.
Root login is allowed only for SSH access.
Enable SSH service for root login.
11.
[edit]
root@# set system services SSH
Commit the configuration to activate it on the switch.
12.
[edit]
root@# commit
Safety Warnings Summary
This is a summary of safety warnings. For a complete list of warnings, including translations, see the hardware documentation
at
https://www.juniper.net/documentation/
WARNING: Failure to observe these safety warnings can result in personal injury or death.
Permit only trained and qualified personnel to install or replace device components.
Perform only the procedures described in this quick start and the hardware guide. Other services must be performed only by
authorized service personnel.
Before installing the device, read the planning instructions in the hardware guide to make sure that the site meets power,
environmental, and clearance requirements for the device.
Before connecting the device to a power source, read the installation instructions in the hardware guide.
Manually installing the device in a rack or cabinet at a height above 60 in. (152.4 cm) requires two people to lift the unit and
install mounting screws. To prevent injury, keep your back straight and lift with your legs, not your back.
If the rack or cabinet has stabilizing devices, install them in the rack before mounting or servicing the switch in the rack or cabinet.
Before installing or after removing an electrical component, always place it component-side up on a flat antistatic mat or in
an antistatic bag.
Do not work on the device or connect or disconnect cables during electrical storms.
Before working on equipment that is connected to power lines, remove jewelry, including rings, necklaces, and watches. Metal
objects heat up when connected to power and ground and can cause serious burns or become welded to the terminals.
Power Cable Warning (Japanese)
The attached power cable is only for this product. Do not use this cable for another product.
6
.
Copyright © 2018, Juniper Networks, Inc.
Advertisement
