Connecting Power To The Device; Performing The Initial Software Configuration For Qfx5200 Switches - Juniper QFX5200-48Y Quick Start Manual

Hide thumbs Also See for QFX5200-48Y:

QFX5200-48Y Quick Start Guide

Figure 5: Lock the Mounting Rails to the Rack

Attach a grounding cable to earth ground and then attach it to the chassis grounding points. For full instructions, see

15.

Earth Ground to a QFX5200

Connecting Power to the Device

The device is supplied with two factory-installed power supplies. To connect power to an AC-powered switch:

If the AC power source outlet has a power switch, set it to the OFF (O) position.

Insert the coupler end of the power cord into the AC power cord inlet on the AC power supply faceplate.

Insert the power cord plug into the power source outlet.

If the AC power source outlet has a power switch, set it to the ON (|) position.

Verify that the AC and the DC LEDs are lit green and on steadily.

You must perform the initial configuration of the QFX5200 through the console port using the CLI or through Zero Touch Provisioning

(ZTP). In order to use ZTP to provision the device, you must have access to a Dynamic Host Control Protocol (DHCP) server, and

a File Transfer Protocol (anonymous FTP), Hypertext Transfer Protocol (HTTP), or Trivial File Transfer Protocol (TFTP) server

on which the software image and configuration files are stored. For more information about using ZTP for provisioning the device,

see

Understanding Zero Touch Provisioning

Before you begin connecting and configuring a QFX5200, set the following parameter values on the console server or PC:

Baud Rate—9600

Flow Control—None

Data—8

Parity—None

in the QFX5200 Hardware Guide.

in the Installation and Upgrade Guide.

Connecting

Table of Contents