Safety Warnings Summary - Juniper EX2300 Quick Start Manual

9. (Optional) Specify the system date and time. Select the time zone from the list.
10. The configured parameters are displayed. Enter yes to commit the configuration. The configuration is committed as
the active configuration for the switch.
You can now log in by using the CLI to continue configuring the switch.
Step 3: Keep Going
IN THIS SECTION

Safety Warnings Summary | 6

Power Cable Warning (Japanese) | 7
Contacting Juniper Networks | 7
See the complete EX Series documentation at https://www.juniper.net/documentation/product/en_US/ex2300.
Safety Warnings Summary
This is a summary of safety warnings. For a complete list of warnings, including translations, see the EX Series documentation
at https://www.juniper.net/documentation/product/en_US/ex2300.
WARNING:
Permit only trained and qualified personnel to install or replace switch components.
Perform only the procedures described in this quick start and the EX Series documentation. Other services must be
performed only by authorized service personnel.
Before mounting the switch, read the planning instructions in the EX Series documentation to make sure that the site
meets power, environmental, and clearance requirements for the switch.
Before connecting the switch to a power source, read the installation instructions in the EX Series documentation.
If the rack has stabilizing devices, install them in the rack before mounting or servicing the switch in the rack.
Before installing or after removing an electrical component, always place it component-side up on an antistatic mat
placed on a flat, stable surface or in an antistatic bag.
Failure to observe these safety warnings can result in personal injury or death.
6