Stormscope Page - Garmin G1000 Columbia 350 Cockpit Reference Manual

SECTION 10 – HAZARD
AVOIDANCE
At a map range of less than 25 nm, Stormscope
lightning data is not displayed, but can still be present.
The presence of Stormscope lightning data is indicated
by the annunciation 'LTNG < 25 nm' in the upper right
corner.
Figure 10-5 Lightning Display Range Annunciation
Select 'cell' or 'strike' as the Stormscope
lightning mode on the Navigation Map:
1) From the Navigation Map Page, press the MENU
Key. Select Map Setup and press the ENT Key.
2) Turn the small FMS Knob to select 'Weather' and
press the ENT Key.
3) Turn the large FMS Knob to select 'STRMSCP
MODE'.
4) Turn either FMS Knob to display the Cell/Strike
Window.
5) Turn either FMS Knob to select 'Cell' or 'Strike'.
Press the ENT Key.
6) Push the FMS Knob to return to the Navigation
Map Page.
Clear Stormscope lightning data from the
Navigation Map Page:
1) Press the MENU Key (with the Navigation Map Page
displayed).
2) Turn either FMS Knob to highlight the 'Clear
Lightning Data' field and press the ENT Key.
10-2
Garmin G1000 Cockpit Reference Guide for the Columbia 350/400

Stormscope Page

1) Turn the large FMS Knob until the Map Page group
is selected.
2) Turn the small FMS Knob until the Stormscope Page
is selected.
Figure 10-6 Stormscope Page
Change the Stormscope lightning mode
between 'cell' and 'strike':
1) Select the Stormscope Page.
2) Select the MODE Softkey. The CELL and STRIKE
Softkeys are displayed. Select the CELL Softkey to
display 'CELL' data or select the STRIKE Softkey to
display 'STRIKE' data. 'CELL' or 'STRIKE' is displayed
in the mode box located in the upper left corner of
the Stormscope Page.
NOTE: "Cell mode" uses a clustering program to
identify clusters of electrical activity that indicate
cells.
190-00567-01 Rev. A