Figure 5-21. Stormscope Config Page; Figure 5-23. Stormscope Download Data Page - Garmin GPS 400W, GNC 420W Installation Manual

5.3.17 STORMSCOPE CONFIG Page
The Stormscope pages are only available if one of the RS-232 inputs is configured for
the WX-500.
Select the STORMSCOPE CONFIG Page (see Figure
5-21). This page shows the L3 Communications WX-
500 Stormscope configuration as reported by the WX-
500 through RS-232 data.
Verify that the STATUS field indicates "Ok", and that
the other displayed parameters are correct. Verify that
all the boxes in the lower portion of the page are green.
When a 400W Series unit is used with a WX-500
Stormscope, the "Synchro" or "Serial" heading formats
may be used. If another heading format is used,
lightning strike information is visible on the Weather
Page, but not the Map Page or Arc Page.
5.3.18 STORMSCOPE TEST Page
Select the STORMSCOPE TEST Page (see Figure 5-22).
This page shows current strike activity, WX-500 status,
and the heading supplied by the WX-500. The WX-500
mode may be changed to 'Demo', 'Noise monitor', 'Self
test', 'Strike test', or 'Weather'.
Verify that the WX-500 mode can be changed. Refer to
the WX-500 manual for specific installation test
procedures for the WX-500, using this page to view strike
data, change the WX-500 mode, view WX-500 status,
trigger count, and heading.
5.3.19 STORMSCOPE DOWNLOAD DATA Page
Select the STORMSCOPE TEST Page (see Figure 5-23).
This page shows raw data downloadable from the WX-
500. Optional sets of data include WX-500 software
version, environmental conditions, configuration, and
fault data.
Verify that the configuration data is correct as intended.
To request which packet of data to display, highlight the
data group title and use the small right knob to select the
desired group.
Page 5-20
Rev. E
NOTE
Figure 5-21. STORMSCOPE CONFIG
Figure 5-22. STORMSCOPE TEST
Figure 5-23. STORMSCOPE
DOWNLOAD DATA Page
Page
Page
400W Series Installation Manual
190-00356-02