Stormscope Page - Garmin G1000 Cockpit Reference Manual

SECTION 10 – HAZARD
AVOIDANCE
At a map range of less than 25 nm, Stormscope light-
ning data is not displayed, but can still be present. The
presence of Stormscope lightning data is indicated by the
annunciation 'LTNG < 25 nm' in the upper right corner.
Figure 10-5 Lightning Display Range Annunciation
To select 'cell' or 'strike' as the Stormscope
lightning mode:
1. With the Weather Group selected, press the
ENT key. The cursor flashes on 'STRMSCP
LTNG'.
Turn the large FMS knob to select 'STRMSCP
2.
MODE'.
3. Turn either FMS knob to display the 'Cell/Strike'
window.
Turn either FMS knob to select 'Cell' or 'Strike'.
4.
Press the ENT key.
5. Push the FMS knob to return to the Navigation
Map Page.
To clear Stormscope lightning data from
the Navigation Map Page:
1. Press the MENU key (with the Navigation Map
Page displayed).
Turn either FMS knob to highlight the 'Clear
2.
Lightning Data' field and press the ENT key.

Stormscope Page

1. Turn the large FMS knob until the Map Page
group is selected.
10-2 Garmin G1000 Cockpit Reference Guide for the Mooney M20M & M20R
2. Turn the small FMS knob until the Stormscope
Page is selected. This is the third rectangular
page icon.
Figure 10-6 Stormscope Page
To change the Stormscope lightning mode
between 'cell' and 'strike':
1. Select the Stormscope Page.
Press the MODE softkey. The CELL and STRIKE
2.
softkeys are displayed. Press the CELL softkey
to display 'CELL' data or press the STRIKE soft-
key to display 'STRIKE' data. 'CELL' or 'STRIKE'
is displayed in the mode box located in the
upper left corner of the Stormscope Page.
NOTE: "Cell mode" uses a clustering program to
identify clusters of electrical activity that indicate
cells.
To change the viewing mode between 360˚
and 120˚:
1. Select the Stormscope Page.