Clearing The Stormscope ® Page; Changing The Stormscope ® Display View; Changing The Storm Data Display Range - Garmin GTN 725 Pilot's Manual

12.2.2
Foreword
Routinely clearing the StormScope Page of all discharge points is a good
Getting
way to determine if a storm is building or dissipating. In a building storm
Started
discharge points reappear faster and in larger numbers. In a dissipating storm
Audio &
discharge points appear slower and in smaller numbers.
Xpdr Ctrl
Com/Nav
FPL
Direct-To
NOTE: When Heading is not available (N/A), the pilot must clear the strikes
after each turn.
Proc
12.2.3
Charts
The Lightning Page displays either a 360° or a 120° viewing angle.
Wpt Info
Map
Traffic
Terrain
Weather
Nearest
Services/
Music
Utilities
System
Messages
12.2.4
Symbols
Storm data can be displayed on the Map page 2000 NM zoom scale, but
the data only goes out as far as the StormScope can report (200 NM). The
Appendix
12-30
Index
Clearing the StormScope
1. While viewing the Weather StormScope page, touch the Clear
Strikes key to clear lightning strikes.
2. Lightning strikes will be cleared from the display and the Rate
value will be reset.
Changing the StormScope
1. While viewing the Weather StormScope page, touch MENU.
2. Touch the 360° or Arc to select the display view.
Figure 12-43 StormScope 360º and Arc Display Views

Changing the Storm Data Display Range

GTN 725/750 Pilot's Guide
Page
®
Display View
®
190-01007-03 Rev. C