Navigation Source - Garmin G1000 Columbia 350 Cockpit Reference Manual

SECTION 2
FLIGHT INSTRUMENTS
Bearing Source
Waypoint
Identifier
Figure 2-27 BRG1 Information Window
Figure 2-28 BRG2 Information Window

Navigation Source

Change CDI navigation sources:
1) Press the CDI Softkey to change from GPS to
VOR1/LOC1.
2) Press the CDI Softkey again to change from VOR1/
LOC1 to VOR2/LOC2.
3) Press the CDI Softkey a third time to return to
GPS.
When using GPS as the navigation source, the following
may appear:
• LOI - GPS position integrity is inadequate for the
current procedure being flown. If GPS is being used
as primary navigation, and LOI is annunciated, other
means of primary navigation will be required, such
as VHF. LOI is also displayed during GPS position
initialization.
2-12
Distance to
Bearing
Pointer
Source
Icon
Distance to
Bearing Source
Waypoint
Identifier
Bearing
Pointer
Source
Icon
Garmin G1000 Cockpit Reference Guide for the Columbia 350/400
• WARN – GPS detects a position error.
• OBS – Displayed when operating in OBS Mode.
• SUSP – Displayed when in OBS Mode indicating
GPS waypoint sequencing is suspended.
• DR – Navigating using Dead Reckoning due to an
error in the GPS solution.
Figure 2-29 GPS LOI, GPS SUSP, LOC1 and VOR2
Enable/disable OBS Mode while navigating
with GPS:
1) Press the OBS Softkey to select OBS Mode.
2) Turn the CRS Knob to select the desired course
to/from the waypoint.
3) Press the OBS Softkey again to disable OBS
Mode.
NOTE: The OBS Softkey is only displayed when
navigating an active leg using GPS.
190-00567-01 Rev. A