Pad Parameter - Akai MPC X User Manual

Pad Parameter

In the Pad Parameter Q-Link Edit Mode, the Q-Link knobs control the same pad parameter for the each of the 16
pads in the current pad bank.
For example, if the Parameter is set to Level, the 16 Q-Link knobs will adjust the 16 independent Level settings for
each pad in the current pad bank. You could then set the Parameter to Pan and use the Q-Link knobs to adjust the
panning of all 16 pads.
Next to the top row of Q-Link knobs on the screen, tap one of these tabs to select the type of parameter you want to
control with the Q-Link knobs:
Mixer: general mixer parameters
Program: pad parameters (i.e., parameters used in Program Edit Mode)
Use the Parameter field to select the parameter you want to control with the Q-Link knobs.
Mixer: Off, Level, Pan, Pad Mute, Pad Solo, Send 1–4
Program:
Off
Tuning
Filter Cutoff
Filter Resonance
Filter Env Amount
Amp Env Attack
Amp Env Decay
Amp Env Release
Tap the Momentary checkbox to turn momentary behavior on or off.
When on, moving the Q-Link knob will adjust its parameter, but the parameter will immediately return to its
original position (when you turned Momentary on) when you release the Q-Link knob.
When off, moving the Q-Link knob will adjust its parameter, and the parameter will remain at its new setting
when you release the Q-Link knob.
Amp Env Hold Layer Sample Pan (1–4)
Amp Env Sustain Layer Semi Tune (1–4)
Filter Env Attack Layer Fine Tune (1–4)
Filter Env Hold Velocity to Start
Filter Env Decay Vel to Filter Attack
Filter Env Sustain Velocity to Env Amount
Filter Env Release Velocity to Filter
Layer Level (1–4) LFO to Pitch
LFO to Filter Velocity to Amp
LFO to Amp Velocity to Pan
LFO to Pan Layer Direction (1–4)
LFO Wave Layer Offset (1–4)
LFO Rate
LFO Sync
Velocity to Pitch
Vel to Volume Attack
281