Akai MPC X User Manual page 279

When Type is set to Pad:
Mixer: Off, Level, Pan, Pad Mute, Pad Solo, Send 1–4
Program:
Off
Tuning
Filter Cutoff
Filter Resonance
Filter Env Amount
Amp Env Attack
Amp Env Decay
Amp Env Release
Insert 1–4: Off, other available parameters depend on the effect
Tap the Momentary checkbox to turn momentary behavior on or off.
When on, moving the Q-Link knob will adjust its parameter, but the parameter will immediately return to its
original position (when you turned Momentary on) when you release the Q-Link knob.
When off, moving the Q-Link knob will adjust its parameter, and the parameter will remain at its new setting
when you release the Q-Link knob.
When an audio track is selected:
Next to the top row of Q-Link knobs on the screen, tap one of these tabs to select the type of parameters you want
to control with the Q-Link knobs:
Mixer: general mixer parameters
Insert 1–4: parameters for its program insert effects
Use the Parameter field to select the parameter you want to control with the Q-Link knobs.
Tap the Momentary checkbox to turn momentary behavior on or off.
When on, moving the Q-Link knob will adjust its parameter, but the parameter will immediately return to its
original position (when you turned Momentary on) when you release the Q-Link knob.
When off, moving the Q-Link knob will adjust its parameter, and the parameter will remain at its new setting
when you release the Q-Link knob.
Amp Env Hold Layer Sample Pan (1–4)
Amp Env Sustain Layer Semi Tune (1–4)
Filter Env Attack Layer Fine Tune (1–4)
Filter Env Hold Velocity to Start
Filter Env Decay Vel to Filter Attack
Filter Env Sustain Velocity to Env Amount
Filter Env Release Velocity to Filter
Layer Level (1–4) LFO to Pitch
LFO to Filter Velocity to Amp
LFO to Amp Velocity to Pan
LFO to Pan Layer Direction (1–4)
LFO Wave Layer Offset (1–4)
LFO Rate
LFO Sync
Velocity to Pitch
Vel to Volume Attack
279