Basic Hardware Installation
D E C . 2 0 1 1 — E F T R E V I E W D R A F T — C I S C O C O N F I D E N T I A L
Verify the Router Basic Installation
After you connect the router to the network and power on the router, verify that the installation was
successful by performing the checks described in this section.
Check the System (SYS) LED
To verify that the router has been successfully installed, check the System (SYS) LED on the router base
(Figure
Sequence
1
2
3
Figure 6-7
Cisco 1240 Connected Grid Router Hardware Installation Guide
6-8
6-7). As the router starts up, the SYS LED will show these states:
State
Description
Yellow
System is receiving power.
Green blinking
The system is starting up or power cycling, and loading system
software, including BIOS and operating system.
Green solid
The system is functioning normally.
System (SYS) LED
Chapter 6
Installing the Router
OL-26223-01