Connect To Ac Power - Cisco 1240 Hardware Installation Manual

Chapter 6 Installing the Router
D E C . 2 0 1 1 — E F T R E V I E W D R A F T — C I S C O C O N F I D E N T I A L
To attach the appropriate connector the AC power cable, follow the manual or other instructions
Caution
provided by the electrical equipment vendor, ensuring that you comply with the electrical codes for your
installation location.
Figure 6-3

Connect to AC Power

Follow these steps to connect the router AC connector
When connecting the router AC power connector, always connect the router end of the cable first. When
Caution
removing the AC power connector, always disconnect the router end of the cable last.
Verify that the unit is grounded as described in the chapter
Step 1
Verify that the SD flash memory module is installed correctly as described in the chapter
Step 2
Flash Memory
Turn off power to the AC power source at the designated circuits.
Step 3
Align the notch in the AC power cable connector
Step 4
connector, then push the cable connector into the router connector. When the cable connector is fully
seated, rotate the cable connector ring clockwise until hand-tight.
Confirm the router antennas are connected to the router before you apply power to the router.
Step 5
Connect the other end of the AC power cable to the power source, using the instructions that came with
Step 6
the connecting device.
Turn on AC power at the designated circuits. The router will power on and boot the software image.
Step 7
OL-26223-01
Router AC Power Cable (Router Connector End)
Module.
Cisco 1240 Connected Grid Router Hardware Installation Guide
(Figure 6-4) to an AC power source.
Mounting the Router.
(Figure 6-5) with the key in the router AC power
Basic Hardware Installation
Using the SD
6-5