Cisco 1240 Hardware Installation Manual page 76

Mounting Instructions
D E C . 2 0 1 1 — E F T R E V I E W D R A F T — C I S C O C O N F I D E N T I A L
Item
1
2
3
4
To attach the mounting bracket to the mounting plate, follow these steps and refer to
mounting plate must be installed according to the instructions in the
section.
What You Need
Mounting bracket and hardware included in the
•
Socket wrench that you supply.
•
Assemble four sets of bracket hardware (washer, split lock washer, and bolt) as shown in the section
Step 1
Assemble Bracket Hardware, page
Place the mounting bracket (
Step 2
over the mounting plate quick hang stud (
Step 3 Align the pivot grooves (
Follow these guidelines:
• Each of the four pivot grooves on the bracket must be attached to at least one bracket mount hole on
the mounting plate.
The final desired orientation of the mounting plate and router determine which bracket mount holes
•
are used.
Mount the router according to the instructions in the
•
Thread the serrated nut onto the quick mount stud (
Step 4
Step 5 Insert one bolt assembly (
corresponding bracket mount hole on the mounting plate.
Repeat
Step 6
Step 7 Position the mounting bracket on the mounting plate as needed before further tightening the bolts.
Step 8 Use a socket wrench to evenly tighten all four bolts and the serrated nut to finish installing the bracket
on the plate.
Cisco 1240 Connected Grid Router Hardware Installation Guide
4-14
Description
Pivot grooves (4)
Quick hang notch
Quick hang slots (2)
Wall mount holes (4)
) against the mounting plate (
3
4 ) on the bracket with four of the bracket mount holes (
5 ) through one of the pivot grooves (
Step 5 for the remaining bolt assemblies.
Mounting Bracket
4-12.
) by inserting the bracket quick hang notch
1
6 ).
Router Orientation
) and hand tighten (do not overtighten).
6
Chapter 4 Mounting the Router
Figure
Install the Mounting Plate on a Pole
Kit.
2 ) on the mounting plate.
section.
4 ) on the bracket and then through the
4-12. The
OL-12345-01