Connect To Ac Power - Cisco 4451 ISR Hardware Installation Manual

Chapter 3 Install and Connect Cisco 4000 Series ISRs
When installing the product, please use the provided or designated connection cables/power
Warning
cables/AC adaptors. Using any other cables/adaptors could cause a malfunction or a fire.
Electrical Appliance and Material Safety Law prohibits the use of UL-certified cables (that have
the "UL" shown on the code) for any other electrical devices than products designated by CISCO.
The use of cables that are certified by Electrical Appliance and Material Safety Law (that have
"PSE" shown on the code) is not limited to CISCO-designated products. Statement 371.

Connect to AC Power

If your router uses AC power, connect it to a 15 A, 120 VAC (10 A, 240 VAC) circuit with overcurrent
protection.
Note
The input voltage tolerance limits for AC power are 90 and 264 VAC.
Note
This product requires surge protection to be provided as part of the building installation. To comply with
the Telcordia GR-1089 NEBS standard for electromagnetic compatibility and safety, an external surge
protective device (SPD) is required at the AC power service equipment.
Warning AC connected units must have a permanent ground connection in addition to the power cable
ground wire. NEBS-compliant grounding satisfies this requirement. Statement 284
This product requires short-circuit (overcurrent) protection, to be provided as part of the
Warning
building installation. Install only in accordance with national and local wiring regulations.
Statement 1045
This product relies on the building's installation for short-circuit (overcurrent) protection.
Warning
Ensure that the protective device is rated not greater than:
15A, 120VAC (16A, 240VAC). Statement 1005
OL-32185-02
Hardware Installation Guide for Cisco 4000 Series Integrated Services Routers
Connect Power
3-21