Siemens SIDOOR AT40 System Manual page 118

Operating principle
Action
1
2
3
4
5
Note
Parameter changes are accepted with the door at a complete stop or in the OPEN or
CLOSED position.
Risk of injury due to moving mechanical parts
After changes to the parameters of the door the permissible energies and forces have to be
checked by service staff and adjusted if they exceed their limit values.
Menu navigation
The menu-based operation of the SIDOOR Service Tool is described in the section
Navigation structure SIDOOR SERVICE TOOL (Page 118).
Door control units SIDOOR AT40 and ATD400V for elevators
System Manual, 06/2018, A5E42192709-AC
Select required parameter
Activate parameter for setting
using the Return key
Increase or decrease parameter
value
Accept parameter value by press-
ing Return key again
Select the next parameter
•
(Step 1)
or
exit the menu
•
WARNING
Key Remarks
Parameter value flashes
Displayed parameter value stops flashing
after acceptance.
-
SIDOOR SERVICE TOOL
7.3 Operation
117