Siemens SIDOOR AT40 System Manual page 128

Parameter assignment and configuration
Risk of injury and material damage due to excessive force of the door
Exceeding the maximum static closing force or the opening force in some cases may lead
to injuries to persons or damage to the door drive and mechanical components of the door.
After commissioning, have the maximum static forces checked by the service personnel,
and adjusted to the limit value if it is excessive.
Note the limits of the applicable standard and adjust the setting accordingly.
Note
Application-specific measures for emergency operation
In the event of a control device failure, measures must be taken for emergency operation
according to the application.
Modifications to the door drive
Loss of liability for defects and material damage
Changes to the door drive lead to the loss of liability for defects and compensation rights,
and the correct function of the door drive is no longer guaranteed.
Observe the following rules:
• Do not make any modifications to the door drive (motor, controller, power supply).
• Do not make a permanent connection as this does not ensure a proper and required
• Do not remove the protective Schuko plug under any circumstances (for example by
• The power supply cord of the power supply (SIDOOR TRANSFORMER or SIDOOR NT
Door control units SIDOOR AT40 and ATD400V for elevators
System Manual, 06/2018, A5E42192709-AC
WARNING
CAUTION
necessary disconnection from the mains.
cutting it off).
40) cannot be replaced. Scrap the power supply if the supply cable is damaged.
Connecting and commissioning
8.1 Overview of safety and commissioning
127