Siemens SIDOOR AT40 System Manual page 81

Controllers
4.7 Operating and parameterizing controllers
Static force limit close
This force is in effect during the closing movement if a close command is set.
Figure 4-7 Current – force – motor characteristic in closing direction
Adjustment ranges
The value of the parameter must be selected so that the door moves across the entire door
width in the closing direction if a close command is set. Inadequate force can lead to an
obstruction of the door.
The closing force can be set for the geared motors within the adjustment ranges of the
parameters (see section Profiles and adjustment ranges (Page 136)).
80
Door control units SIDOOR AT40 and ATD400V for elevators
System Manual, 06/2018, A5E42192709-AC