Siemens SIDOOR AT40 System Manual page 75

Controllers
4.7 Operating and parameterizing controllers
Operation
Parameters can be changed in both of the following menus:
"MAIN MENU > Quick setup > Parameter setting"
●
"MAIN MENU > General setup > Profile parameters"
●
The desired parameter is selected with the menu selection keys
the setting with the Enter key
The parameter value can then be increased or decreased by pressing the corresponding key
(see above). The value is applied by pressing the Enter key again.
Menu navigation
You can find the menu navigation of the SIDOOR Service Tool in the SIDOOR SERVICE
TOOL (Page 115) section.
Digital display "H1"
You can see the operating states on the "H1" display. You can find the meaning of the digital
display in the section Operating state display (Page 134).
74
Enter key – jumps to the next menu below
Escape key – jumps back to the menu above
Menu selection key – increases a parameter value
Menu selection key – decreases a parameter value
(parameter value flashes).
Door control units SIDOOR AT40 and ATD400V for elevators
System Manual, 06/2018, A5E42192709-AC
and , and activated for