Table of Contents
Advertisement
CDM-600L Satellite Modem
Front Panel Operation
ODU: LNB-LO
LNB-LO: FREQUENCY = 00000 MHz
Select a parameter to edit using the [←] [→] arrow keys.
FREQUENCY
MIX
6.3.8
FAST
FAST OPTIONS: SET
MOTHERBOARD S/N 123456789
Select whether to change or view current settings using [←][→] arrow keys.
6.3.8.1
FAST: SET
ENTER 20 CHAR CODE BELOW AND PRESS ENTER
XXXXXXXXXXXXXXXXXXXX
FAST is the way to enable new options in the modem. Obtain the FAST code for the new
option from Comtech EF Data. Enter the code carefully. Use the [←][→] arrow keys to
move the cursor to each character. Use the [↑] [↓] arrow keys to edit the character, then
press ENTER. The modem will respond with "Configured Successfully" if the new
FAST option has been accepted.
MIX = HIGH (-)
Sets the LO frequency in the LNB for the downconversion. Entering a
nonzero value for LNB LO will cause the RX IF frequency programming
under CONFIG: RX: RX-IF to be entered and displayed as the actual RX
frequency for the satellite terminal. Use [↑] [↓] and [←] [→] arrow keys to
set the LO frequency and press ENTER.
Sets the polarity for the upconversion mix in the LNB. Use [↑] [↓] arrow
keys to select HIGH (-) for high side inverting mix, or LOW (+) for low side
noninverting mix and press ENTER.
VIEW
6–42
MN/CDM600L.IOM
HW REV 2.0
Revision 0
Advertisement
Table of Contents
