Programming An Entrance Gate; Reprogramming A Button; Operating The Homelink - Lexus LX 470 Owner's Manual

Table of Contents

Advertisement

INTERIOR EQUIPMENT
3. Press and release the vehicle's programmed HomeLink
button twice. The garage door may open. If the door does
open, the programming process is complete. If the door does
not open, press and release the button a third time. This third
press and release will complete the programming process by
opening the garage door.
The ceiling mounted garage door opener motor should now
R
recognize the HomeLink
unit and be able to activate the
garage door up/down.
4. Repeat steps 1 through 3 for each remaining HomeLink
button to program another rolling code system.

Programming an entrance gate /

Programming all devices in the Canadian
market
1. Decide which of the 3 HomeLink
program.
2. Place your hand−held gate/device transmitter 25 to 75 mm
(1 to 3 in.) away from the surface of the HomeLink
Keep the indicator light on the HomeLink
programming.
3. Press and hold the selected HomeLink
4. Continuously press and release (cycle) the hand−held
gate/device transmitter button every two seconds until step 5
is complete.
5. When the indicator light on the HomeLink
slow to a rapid flash after 20 seconds, you can release both
buttons.
64
R
6. Test the operation of the HomeLink
programmed button. Check to see if the gate/device operates
correctly.
7. Repeat steps 1 through 6 for each remaining HomeLink
button to program another device.
Programming other devices
To program other devices such as home security systems,
home door locks or lighting, contact your authorized Lexus
R
dealer for assistance.

Reprogramming a button

Individual HomeLink
reprogram a single button, follow the procedure "Programming
the HomeLink
R
buttons you want to
(b) Operating the HomeLink
To operate the HomeLink
R
button to activate the programmed device. The HomeLink
.
indicator light should come on. The HomeLink
R
in view while
send the signal for up to 20 seconds as long as the button is
pressed.
R
button.
R
changes from a
R
by pressing the newly
R
buttons cannot be erased, however, to
R
".
R
R
, press the appropriate HomeLink
R
R
R
R
continues to

Advertisement

Table of Contents
loading

Table of Contents