Table of Contents
Advertisement
WINDSHIELD WIPER AND WASHER
SWITCH
12X004c
" 1 Interval adjuster
2 Washer on
To turn the wipers on, move the lever down until you reach
the desired speed setting.
The ignition key must be in the "ON" position.
There are 3 settings:
"INT" position: Intermittent operation
"LO" position: Low speed operation
"HI" position: High speed operation
Twist the interval adjuster upward to increase the wiping
time interval between sweeps, and downward to decrease
it.
The wiper lever must be in the "INT" position.
To make the washer squirt, pull the lever toward you and
release it.
Even if the wiper lever is in the "OFF" position, the wipers will
automatically operate a couple of times.
The low washer fluid warning light in the instrument cluster
comes on when the fluid level in the tank becomes nearly
empty. For information on adding washer fluid, see "Adding
washer fluid" on page 331.
In cold weather, warm the windshield with the defroster before
using the washer. This will help prevent icing, which could
block your vision.
NOTICE
Do not operate the wipers if the windshield is dry. It may
scratch the glass.
SWITCHES
27
Advertisement
Table of Contents
