If [Open Stapler Front Door, Then Rotate Fs8 Until The Blinking In Panel Disappears] Message Is Displayed - Konica Minolta bizhub Press 1250P Additional Information

5.14 Troubleshooting - If [Mishandled paper] Message Is Displayed
5.14.2 If [Open stapler front door, then rotate FS8 until the blinking in panel disap-
pears] Message Is Displayed
The stacker of Finisher FS-532 has a vertical alignment plate to coordinate the position of paper in feeding
direction. Depending on the position where the vertical alignment plate has stopped, the jam position display
may flash to show unavailability of print operation. At the same time, the message [Open stapler front door,
then rotate FS8 until the blinking in panel disappears] is displayed in the message area of the screen.
Follow the procedure below to stop the flash in the jam position display.
NOTICE
If the lamp is continuously on in the jam position display, remove the paper mishandled in the finisher.
1
Open the finisher front door to check that the jam position display is flashing.
2
Hold Handle [FS9] to pull out the stacker.
3
Turn Knob [FS8] to draw out the vertical
alignment plate of the stacker.
% Locate the vertical alignment plate
within the range indicated by the ar-
row in the illustration.
The lamp flashing in the jam position dis-
play will go off.
bizhub PRESS 1250/1052, bizhub PRESS 1250P, bizhub PRO 951 Additional Information
5
5-29