Preparing The Unit; To Install The Optional Adapter Pcb - Daikin VAM350J7VEB Installer And User Reference Manual

5 Preparation
CAUTION
▪ The appliance is designed to be a built-in appliance. It
must NOT be accessible to the general public.
Adequate measures have to be taken to prevent
access by other than qualified persons.
▪ Check if the installation location can support the unit's
weight. Poor installation is hazardous. It can also cause
vibrations or unusual operating noise.
▪ Provide sufficient service space and inspection holes.
Inspection holes are needed for the air filters, the heat
exchange elements and the fans.
▪ Do NOT install the unit so that it is in contact with a
ceiling or wall, this may cause vibration.
CAUTION
Appliance NOT accessible to the general public, install it in
a secured area, protected from easy access.
This unit is suitable for installation in a commercial and
light industrial environment.
For models 800~2000
NOTICE
This is a class A product. In a domestic environment this
product may cause radio interference in which case the
user may be required to take adequate measures.
Service space
See "6.1 Service space: Heat reclaim ventilation unit" on
5.3

Preparing the unit

5.3.1

To install the optional adapter PCB

For models 350-500-800-1000
a
f
a BRP4A50A (optional accessory)
b KRP2A51 (optional accessory)
c KRP1BA101 (installation box)
f Screw
g Screw (supplied with the installation box)
1 Remove the screws from the unit.
2 Attach the optional adapter PCB (KRP2A51) in the installation
box (KRP1BA101).
3 Follow the installation instructions provided with the option kits
(BRP4A50A, KRP2A51 and KRP1BA101).
4 Guide the PCB wire through the dedicated holes and attach it
as instructed in "6.5.2 Opening the switch box" on
5 Attach the options to the unit, as shown in the figure.
Installer and user reference guide
12
page 15.
b
f
c
g
f
page 17.
6 After the wires are connected, fasten the switch box cover.
For model 650
a d
f
a BRP4A50A (optional accessory)
b KRP2A51 (optional accessory)
c KRP1BA101 (installation box)
d EKMP65VAM (mounting plate)
f Screw
g Screw (supplied with the installation box)
1 Remove the screws from the unit.
2 Attach the optional mounting plate (EKMP65VAM) to the unit.
3 Attach the optional adapter PCB (KRP2A51) in the installation
box (KRP1BA101).
4 Follow the installation instructions provided with the option kits
(BRP4A50A, KRP2A51 and KRP1BA101).
5 Guide the PCB wire through the dedicated holes and attach it
as instructed in "6.5.2 Opening the switch box" on
6 Attach the options to the optional mounting plate, as shown in
the figure.
7 After the wires are connected, fasten the switch box cover.
For models 1500+2000
b
f
c
g
f
b + c
f
a
a BRP4A50A (optional accessory)
b KRP2A51 (optional accessory)
c KRP1BA101 (installation box)
e EKMPVAM (mounting plate)
f Screw
g Screw (supplied with the installation box)
1 Remove the screws from the middle of the plate connecting the
2 units.
b
c
f
g
f
page 17.
e
VAM350~2000J7VEB
Heat reclaim ventilation unit
4P487293-1A – 2018.05