Preparing To Move The Unit; Removing Unit From The Skid; Unit Ventilator Installation; Before Sliding The Unit Into Place - Daikin ARQ Installation And Maintenance Manual

Preparing to Move the Unit

Move the unit ventilator to the correct location. See Table 1 on
page 6 for approximate shipping weights.
Carefully remove unit ventilator from wood skid. Be sure to
properly dispose of the skid in accordance with local recycling
rules and guidelines.

Removing Unit from the Skid

Remove fasteners at each end which hold the unit to the skid
and carefully slide the front of the unit off the skid (1). Tip
unit forward until the bottom of the slotted front kickplate is
resting on the floor (2). Lift rear of unit off of the skid by tipping
unit forward while supporting the unit from the front, until it is
possible to slide skid out from under the unit. GENTLY LOWER
the rear of the unit to the floor (3).
Figure 27: Removing unit from skid
1. Carefully slide the front of the unit off the front of the skid.
2. While supporting unit from the front, slowly tip unit forward
until bottom of kickplate is resting on floor. Lift skid slightly
and GENTLY lower the rear of the unit to the floor while
pulling skid back (DO NOT LET THE UNIT DROP).
Tip forward until kickplate
rests on floor

Unit Ventilator Installation

Before setting the unit ventilator in position, be sure that field-
supplied electrical connections are in place, de-energized and
in accordance with the plans.

Before Sliding the Unit into Place

Sliding of this unit to the wall can be made easier with the
assistance of Caster Kit P/N 105629001 (Figure 28). A piece of
cardboard placed under the unit will make this job easier and
reduce marring the floor. (Do not leave cardboard under unit
after installation.)
Be certain that the field-supplied electrical connections are in
place, de-energized and in accordance with the plans.
www.DaikinApplied.com

Installing Casters

If the unit was ordered with the optional caster wheels, install
them as follows:
1.
2.
3.
4.
5.
6.
7.
Figure 28: (Optional) indoor section caster installation
Raises and
lowers caster
Approx. 10"
Left Caster
Kickplate
15
Remove the left and right front access panels.
With the one caster (left end), ensure the caster is fully up
(turn bolt clockwise to raise, counterclockwise to lower).
Locate in the left end compartment the slots and bolt
location.
Insert the tines of the caster channel into the slots.
Securely bolt the front to the unit front rail.
Repeat for the right caster wheels (2).
Slowly engage the casters by lowering the bolt. Make all
caster adjustments equally before raising the unit.
When full engaged, the unit will roll forward up to the wall.
When the unit is in position, reverse the procedure and
remove the caster kit. Save the caster kit for future unit
servicing or replacement.
Counter-clockwise to lower
Clockwise to raise
Raises and low-
ers casters (two
on compressor
end of unit)
Caster mounting cut-out
Right Caster
IM 1083-3