Operating Procedure; To Change Settings - Daikin VAM350J7VEB Installer And User Reference Manual

8 Configuration
8.1

Operating procedure

The heat reclaim ventilation unit settings can be adjusted using the
controller of either the heat reclaim ventilation unit or the air
conditioner.
Initial settings
▪ Mode numbers 17, 18, and 19: group control of heat reclaim
ventilation units.
▪ Mode numbers 27, 28, and 29: individual control.
8.1.1

To change settings

Case 1: Change settings
With BRC1E53
Make sure that the switch box lid on the heat reclaim ventilation unit
is closed.
1 Briefly press a button to turn on the screen light.
2 Press and hold the Cancel button (a) for at least 4 seconds to
enter the Service Settings menu.
3 Go to Field Settings with the Up/Down buttons and press the
Menu/Enter button (b).
4 Press the Left/Right buttons to highlight the number under
Mode.
5 Press the Up/Down buttons to select the required mode
number.
Result: From mode 20 and up, you also have to select a unit
number for individual control.
6 Use the Left/Right buttons to highlight the number under Unit
No..
7 Use the Up/Down buttons to select an indoor unit number.
Selecting a unit number is NOT necessary when configuring the
entire group.
8 Use the Left/Right buttons to select a switch number (0 to 15) to
change.
In case of individual settings:
Field Settings
Unit No. Mode
0 20
Return Setting
In case of group settings:
Field Settings
Mode
10
Return Setting
9 Use the Up/Down buttons to select the required position
number.
10 Press the Menu/Enter (b) button and confirm the selection with
Yes.
Field Settings
Save the settings?
Yes No
Return Setting
11 After you have completed all changes, press the Cancel button
(a) twice to return to the normal mode.
Installer and user reference guide
24
Case 2: Change settings
With BRC301B61
Make sure that the switch box lid on the heat reclaim ventilation unit
is closed.
1 With the unit in normal mode, press the Inspection/Trial button
(a) for more than 4 seconds to enter the local setting mode.
2 Use the Ventilation mode button (up - b) and the Airflow rate
button (down - b) to select a mode number.
Result: The code display is blinking.
3 To configure settings for individual units under group control,
press the Timer setting on/off button (c) and select the number
of the unit that you want to configure.
4 To select the setting switch number, press the top section of the
Timer button (d). To select the setting position number, press
the lower section of the Timer button (e).
5 Press the Program/Cancel button (f) once to enter the setting.
Result: The code display stops blinking and lights up.
6 Press the Inspection/Trial button (a) to return to normal mode.
SETTING
c
f
a
d e
INFORMATION
Setting 18(28)-11 CANNOT be selected with this controller.
b
a
b
VAM350~2000J7VEB
Heat reclaim ventilation unit
4P487293-1A – 2018.05