Controller For Heat Reclaim Ventilation Units - Daikin VAM350J7VEB Installer And User Reference Manual

8 Configuration
Time to clean filter indication
When the filter pressure drop becomes too large, the following
message or icon is displayed at the bottom of the basic screen: Time
to clean filter or . Clean the filters. For more information, see
"11 Maintenance and service" on
Cool
Set to
28
°C
Time to clean filter
To remove the Time to clean filter indication
1 Press the Menu/Enter button.
2 Press the Up/Down buttons to select Reset Filter Indicator.
3 Press the Menu/Enter button.
Result: You return to the basic screen. The Time to clean filter
indication is no longer displayed.
Main Menu 1/3
Reset Filter Indicator
Airflow Direction
Individual Air Direction
Quick Start
Ventilation
Energy Saving Options
Return Setting
Cool
Set to
28
°C
About error indications
If an error occurs, there is an error icon in the basic screen and the
operation lamp blinks. If a warning occurs, ONLY the error icon
blinks and the operation lamp does NOT. Press the Menu/Enter
button to display the error code or warning and contact information.
Cool
Set to
28
°C
Error : Push Menu Button
The error code blinks and the contact address and model name
appear as shown below. In this case, notify your dealer about the
error code.
Error Code:A1
Contact Info
0123 – 4567 – 8900
Indoor Model ––– /000
––– /000
Outdoor Model
Return
8.4.2 Controller for heat reclaim ventilation
units
For non-independent systems, starting, stopping and setting a timer
is NOT possible with this controller (BRC301B61). In such cases,
use the air conditioner controller (BRC1E53) or the central controller.
Installer and user reference guide
34
page 40.
6
FRESH UP
11
12
13
10
TEST
1 Operation lamp
This red pilot lamp lights up while the unit is in operation.
2 Operation/Stop button
Press this button once and the unit starts to operate. Press this
button again and the unit stops.
3 Air flow rate changeover button
Use this button to change the air flow to " " Low, "
FRESH UP" Low Fresh-up, or "
mode.
When this indication does NOT show, the volume of outdoor air
supplied into the room and that of the room air exhausted
outdoors is equal.
For "FRESH UP" operation
▪ If the Fresh-up setting is set to "Fresh up air supply": The
volume of outdoor air supplied into the room is larger than that
of room air exhausted outdoors. This prevents odours and
moisture from kitchens and toilets from flowing into the room.
This is the factory setting.
▪ If the Fresh-up setting is set to "Fresh up air exhaust": The
volume of room air exhausted outdoors is larger than that of
outdoor air supplied into the room. This prevents hospital
odours and airborne micro-organisms from flowing out of the
room into the corridors.
To change this setting, see
4 Ventilation mode changeover button:
A
(
(
" " Automatic mode
The unit's temperature sensor automatically changes the
operation mode of the unit to Bypass mode or Heat Reclaim
Ventilation mode.
" " Heat Reclaim Ventilation mode
1 2
8
4
3
9
" High, "
FRESH UP" High Fresh-up
"8.2 List of settings" on page 25.
VAM350~2000J7VEB
Heat reclaim ventilation unit
4P487293-1A – 2018.05