Still Images; Export/Import Still Images To/From The Pc - Datavideo SE-650 Instruction Manual

Note: Please make sure PIP, keyer and logo are turned off.
3. Press the MENU button to open the OSD menu on the Multiview display.
4. In the Stills option, browse to Grab Still and select GRAB to grab the logo to a desired location, for
example Still 2.
Note: You are allowed to select a location for Grab/Save/Load Still features. The Stinger (Clip)
feature does not allow you to select the destination, which is fixed to Still 2 only.
5. Browse to Save Still after the logo is grabbed and save Still 2 to a memory location on the
machine.
Note: To make sure the saved logo will be loaded to Still 2 on the next machine boot, before
rebooting your machine, please first go to Load Still and load the logo saved at Step 5 to Still 2.
6. Browse to the Logo option and select Still 2 as the logo source (Logo Src). Logo Fill should be
assigned to Still 2 as well.
7. In the Logo sub-option, select keyer type as Luma and Self. The recommended Lift is 0% and Gain
is 2.0.
8. After the logo is successfully configured, pressing the Logo ON/OFF button allows you to turn
ON/OFF the logo. Once enabled, the logo will appear on the PVW and PGM views at the same
time.

5.3 Still Images

This section will show you how to import still images from the PC to the switcher and load the
imported file to the switcher. You are also allowed to export still images from the switcher to the PC
for file editing.

5.3.1 Export/Import Still Images to/from the PC

The switcher's Image Import/Export software (SwitcherImageImEx_vx.x.x.msi) allows the user to
import still pictures from the PC to the designated Still number of the switcher and vice versa. The
software installation package can be downloaded from the product page. Features of the
Import/Export software are listed as follows:
- Supported file formats are BMP, JPG, PNG, and PIC.
- Minimum resolution is 1280 x 720.
- Independent exported still pictures in BMP format.
Please follow the steps below to set up the system before installing the software.
• First connect the SE-650 to a Windows computer using an RJ-45 Ethernet cable.
• Since the SE-650 has a default IP address of 192.168.1.101 so the computer should be given
the IP settings that match the same IP range as the switcher.
• Turn on the Windows computer and manually set the IP to 192.168.1.X within the Windows
Network and Sharing Centre.
After the connection is successfully established, the system setup is complete. Now install the
Switcher Image Import/Export utility on the computer.
54