Precautions For Correct Use - Omron V680S-HMD63-PNT User Manual

Always observe the following precautions to prevent operation failures, malfunctions, and adverse effects on
performance and equipment.
1. Installation and Storage Environment
Do not use or store the Product in the following locations.
• Locations subject to combustible gases, explosive gases, corrosive gases, dust, dirt, metal powder,
or salt
• Locations where the specified ambient temperature range or ambient humidity range is exceeded
• Locations subject to extreme temperature changes that may result in condensation
• Locations subject to direct vibration or shock outside the specified ranges
2. Installation
• This Product uses a frequency band of 13.56 MHz to communicate with RF Tags. Some transceivers,
motors, inverters, switch-mode power supplies, and other devices generate electrical noise that will
affect these communications. If any of these devices are located in the vicinity of the Product, they
may affect communications with RF Tags, and may possibly damage the RF Tags. Prior to using the
Product in the vicinity of any of these devices, perform a test to determine whether the Product can
be used under the resulting influence.
• Connect the control signal to the positive and negative sides of the power supply.
The control signal is used to change the operation mode of the Reader/Writer.
Refer to Connector in Section 3 Component Names for the connection methods.
p.61
• Do not exceed the rated voltage range. Doing so may result in Product destruction or burning.
• Tighten the mounting screws to a torque of 1.2 N·m.
• Tighten the Cable connector to a torque of 0.39 to 0.49 N·m.
• Mount the two-way Branch Cable with an M4 screw.
3. Application Methods
• Do not drop the Product.
• Do not pull on the Cables with excessive force.
• Do not attempt to disassemble, repair, or modify the Product.
• If you use the products in an environment that will subject them to oil, confirm that the oil that is used
will not adversely affect the resins used in the products.
4. Maintenance
• Perform inspections both daily and periodically.
Refer to Maintenance and Inspection in Section 10 Maintenance and Inspection for the items to inspect.
p.228

Precautions for Correct Use

Introduction
RFID System
5
User's Manual
(PROFINET)