Omron V680S-HMD63-PNT User Manual page 76

Section 4
Installation and Connections
 V680-D8KF67
Mount the RF Tag with M3 screws.
Tighten the screws to a torque of 0.6 N·m.
Refer to RF Tag Installation Precautions in Section 11 Appendices for information on the effect of metal at the back surface,
Mutual Interference of RF Tags and Influence of Inclination of the V680-D8KF67.
p.247
 V680-D8KF67M
Mount the V680-D8KF67M to a metal surface.
Mount the RF Tag with M3 screws.
Tighten the screws to a torque of 0.6 N·m.
When you install the RF tag, prepare the metal plate as shown in the figure below.
When the metal plates size is larger than the below illustration, communication range will change.
Please confirm the influence well.
Material: Steel
Although it is possible to use SUS, aluminum or brass in addition to steel as the metal plate, communications range is
influenced by the material. Do not use resin as the metal plate.
Refer to RF Tag Installation Precautions in Section 11 Appendices for information on the effect of surrounding metal, Mutual
Interference of RF Tags and Influence of Inclination on the V680-D8KF67M.
p.247
RFID System
74
User's Manual
(PROFINET)
Two, M3 holes
32
±0.2
40
(Unit: mm)
Mounting Hole Dimensions
Two, M3 holes
M3 screw
Marked side
Mounting Hole Dimensions
Two, M3 holes
M3 screw
Marked side
V680-D8KF67M
Screw mounting
Metal plate
32
±0.2
32
±0.2
32
±0.2
32
±0.2