Troubleshooting The Auto Stop Feature - Precor TRM10/GEN06 Service Manual

Troubleshooting the Auto Stop Feature

Auto stop is a feature incorporated into all next generation Experience
series treadmills. This procedure will provide troubleshooting steps
for the Auto Stop feature
Procedure:
1 If the Auto Stop feature does not function continue with step 3.
2 If the Console is displaying Temporarily Out of Order (P80) or
Please use another Treadmill (P30, P20, P10) go to step 7.
3 Check the treadmill to ensure the Auto Stop hardware is installed.
See Figure Below.

If the Auto Stop hardware is not installed, contact Precor
customer support to see if your treadmill is compatible for the
Auto Stop or arrange the installation of the Auto Stop hardware.

If the Auto Stop hardware is installed, Continue.
4 Verify that the Auto Stop cable was plugged into the correct port in
the console. The connector for the Auto Stop is the same number of
pins as the connector for the heart rate grips, and you need to make
sure that they were not reversed.

If the cables were reversed, swap the connectors and re-test.

If the cables were correctly connected, continue
5 If the Auto Stop hardware is installed, access the club settings and
check if the Auto Stop feature is enabled. If it is not enabled,
enable the feature. See Procedure (P80), (P30), (P20) or (P10)
Setting Club Parameters.
6 If the Auto Stop feature is enabled and you have performed steps 3
and 4 contact Precor customer service.
7 Access the service access software (hardware validation tests), and
select the Auto Stop test (see section-5). If the feature is enabled
the P80 Auto Stop sensor test will count the number of times the
magnet crosses the sensor. The P10, P20, or P30 consoles will
display USER DETECTED if motion is detected from the running deck or
NO USER DETECTED if no motion is detected from the running deck. If
the unit passes this test or a USER DETECTED is displayed and the
Auto Stop feature still does not function contact Precor Customer
Support. If the Auto Stop did not pass the test continue with step
8.
© Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law Page 70