Precor TRM10/GEN06 Service Manual page 133

Running Belt and Deck Cleaning Procedure
11 First, check for proper operation of the safety stop key. Stand to one
side of the treadmill. Ensure that the stop key tether is hanging
straight down from the stop key and is not wrapped around the handle
bars. Push the Quick Start button and wait for the display to count
down and for the running belt to begin moving. Once the running belt
is moving pull the safety stop key tether. See the Figure Below. When
the belt stops reset the safety stop key.
CAUTION: If the running belt does not stop, turn off the power using the
ON/OFF switch at the front of the treadmill and unplug the power cord.
The treadmill must remain out of service until the stop switch is
repaired. If the running belt stops, continue with the cleaning procedure
12 A clean, dry towel approximately 36 inches or 1 meter in length is
required. Fold the towel in half lengthwise, lift the running belt up
and insert the towel beneath the belt so that an end of towel extends
on to each deck trim. See the Figure Below.
13 Stand to one side of the treadmill, push the Quick Start button, grasp
the towel as illustrated in the illustration above. Note: You will
have 3 seconds to firmly grasp your hands on the towel before the
treadmill running belt begins to move. Allow the treadmill to run for
about one minute while holding the towel firmly in place.
CAUTION: If the towel becomes loose it may be pulled into the treadmill's
rollers. Pull the safety key tether to stop the treadmill and retrieve
the towel, no damage should occur. Start the procedure over again. See
Figure Below.
© Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law
Figure 61: Running Belt and Deck Cleaning
Page 131