P80 Console - Precor TRM10/GEN06 Service Manual

The standard access codes use sequential key presses, not simultaneously
holding down multiple keys. The allowable delay between key presses is
short. If too much time is taken between key presses or the wrong key is
pressed, the access procedure will be aborted. If the access is aborted,
it will be necessary to start over from the beginning.

P80 Console

1 Use the System Settings to test your equipment and set parameters that
benefit your users and your facility.
2 The Welcome screen will be the first screen you see when you approach
the P80 console. Press the Pause key and continue holding it down
while you double press (prior to 1.1 version software release) or
single press
order an X configuration on the Volume and Channel key pad (Channel
Up, Volume Down, Volume Up, Channel Down). Release the Pause key
when done pressing the arrows.
Note: The keypad X configuration sequence should be not faster than 1
second between each key stroke. Any speed faster than 1 second may
result in an unsuccessful access to the sign-in screen.
3 The sign-in screen will be displayed. Type in the technician access
,5,1,7,6,5,7,6,1, and then touch OK. The Settings menu will be
displayed.
© Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law
(1.1 version or after software release) in sequential
Figure 1: P80 Sign In Access
Page 13