Running Belt Tracking Adjustment - Precor TRM10/GEN06 Service Manual

Running Belt Tracking Adjustment

Running Belt Tracking Adjustment
1 Place a reference point on the deck right next to one edge of the
running belt so that any side to side movement can be observed.
2 Start the treadmill and set the speed to 1 mph.
Observe the running belt, if the belt starts to drift toward the
3
right, slowly turn the right side take up roller mounting bolt
clockwise until the drifting stops.
4 If the belt starts to drift toward the left, slowly turn the right
side take up roller mounting bolt counterclockwise until the drifting
stops. The adjustments should only be done in 1/4 turn increments.
NOTE: ONLY use the right side take up roller mounting bolt to adjust
tracking.
5 Increase the speed to 3 mph for a minute, then 6 mph, 9 mph and
finally 12 mph, making any small adjustments as needed.
6 Set the treadmill speed to 3 mph and walk on the treadmill for a
couple of minutes. Verify that the belt has not moved. Adjust the
right side take up roller mounting bolt if needed to make final
adjustments.
7 Replace the belt guard, ensuring the belt guard tabs are firmly locked
in the frame locking tabs and snapped onto the take up roller shaft.
8 Replace the end caps or rear guard and motor cover.
© Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law Page 124