Roland VR-700 Quick Reference

VR-700 Function Mode Quick Reference
This publication shows you how to make changes in the parameters related to organ and ensemble sounds. These parameters make up only a portion
of all the parameters that can be set in the Function mode. For detailed explanations concerning these parameters, and for information on all the other
parameters, which are not covered in this publication, refer to the VR-700 Owner's Manual.

Operations in Function Mode

1.
Press the [FUNCTION/ENTER] button to enter Function
mode.
2.
Use the [+] button or [–] button to select the Group.
Refer to the relevant pages in this document to learn about the
correspondence between Groups and what is indicated in this unit's
display.
3.
Press the sound button that corresponds to the
parameter for which you want to change the settings.
Refer to the relevant pages in this document to learn about the
correspondence between the buttons and the parameters.
4.
Use the [+] button or [–] button to change the value of
the setting.
5.
To exit Function mode, press the [DISPLAY/EXIT] button
twice.
Organ Sound Parameters
With the Group already selected, press the [+] button or [–] button until
Parameter Wheel Type
1: VINTAGE 1
2: VINTAGE 2
Value
3: SOLID
4: CLEAN
VINTAGE 1/2 are tonewheels
representative of the 70s/60s.
Remarks SOLID emphasizes the lower-
range harmonics of VINTAGE 1.
CLEAN is free of leakage noise.
Tone button
(blink red)
Parameter Key Off Click Level
Value 0–31
Remarks –
Copyright © 2010 ROLAND CORPORATION
All rights reserved. No part of this publication may be reproduced in any form without the written permission of ROLAND CORPORATION.
Amp Type Organ Fine Tune
1: Jazz oriented
2: Vacuum tube amp for guitar
3: Rock oriented -50– +50 (cent)
4: Readily distorts
5: Level easily set
1, 3, 4, and 5 are amps with
rotating speakers. 2 is a guitar –
amp.
Reverb Send Level Active Amp Enhancer
0–127 OFF, ON
Enhances the distortion
– characteristics according to
the Amp Type
Saving Your Settings As a Favorite
1.
Press the [DISPLAY/EXIT] button twice to exit Function
mode.
2.
While together holding down both the [WRITE] and
[BANK] buttons, press one of the FAVORITE [1]–[8]
buttons to specify the save-destination bank.
3.
While holding down the [WRITE] button, press one of the
FAVORITE [1]–[8] buttons to specify the save-destination
favorite number.
is shown in the display.
Leakage Level
0–127
–
–
–
–
* 5 1 0 0 0
Key On Click Level
0–31
–
–
–
–
1 2 3 1 4 - 0 2 *