Changing the destination
Insert Effects are Connected
By default, the insert effect is inserted immediately after the
input source. The reason for this is to allow for the effects-
processed (wet) sound to be recorded and monitored.
However, sometimes you want to change the connection
order.
On the BR-600, you can accommodate a wide variety of
situations by changing the point to which the insert effects
are connected.
Follow the procedure below to change where insert effects
are connected.
1
Confirm that [PAD] is not lit, then press [EFFECTS].
2
Press CURSOR [
] [
"LOCAT," and press [ENTER].
fig.03-100
3
Turn the TIME/VALUE dial to switch the point to
which the insert effects are connected.
■
INPUT<NORMAL> :
The sound is monitored and recorded after it passes
through the insert effect. Normally you will use the BR-600
with this setting.
fig.03-110
TRACK 1
(REC)
] to move the cursor to
INPUT<REC DRY> :
■
The sound is monitored through the insert effect but is
recorded without the effect (dry). Use this when you wish
to try out various effects after recording.
fig.03-120
TRACK 1
(REC)
TRACK 1–8, 1 2, 3 4, 5 6, 7 8 :
■
The insert effect can be applied to the playback of a track (or
pair of tracks). Use this when you wish to try out effects
after recording the dry sound, or when you wish to apply
effects only to a specific track.
fig.03-130
■
RHYTHM :
The insert effect can be applied to the playback of a Rhythm.
fig.03-140
MASTER :
■
Use this when you wish to apply effects to the entire song,
such as when adjusting the tone or applying a special effect
during mixdown.
fig.03-150
4
Press [EXIT] to return to the Play screen.
* During updating, "Keep power on!" appears in the upper
line of the display, while the lower line shows what is being
processed.
Using the Insert Effects
TRACK 1
(PLAY)
RHYTHM
TRACK 1
(PLAY)
TRACK 8
(PLAY)
RHYTHM
95