Using The Loop Effects; Selecting The Loop Effect - Boss BR-600 Owner's Manual

Using the Loop Effects

Here is an explanation of how to change the various
parameters for the loop effects (chorus/delay/doubling/
reverb).
For an explanation of loop effects, refer to
"Loop Effect Parameter Functions" (p. 120).

Selecting the Loop Effect

1
Confirm that [PAD] is not lit, then press [PAN/EQ/
LOOP FX].
2
Press CURSOR [
"CHO/DLY" or "REV," and press [ENTER].
fig.03-500
3
Press CURSOR [ ] [
is displayed, then turn the TIME/VALUE dial to
select the loop effect.
When using CHO/DLY
Select from "CHORUS," "DELAY," or "DBLN"
(doubling).
fig.03-510
When using REV
Select either "HALL" or "ROOM."
fig.03-520
118
] [ ] to move the cursor to
] until "FX Type" or "Type"
4
To change the settings for the selected effect, press
CURSOR [ ] [ ] to select the parameter and turn
the TIME/VALUE dial to change the set value.
fig.03-530
For a description of the parameters for each
effect, refer to "Loop Effect Parameter
Functions" (p. 120).
5
When you finish making settings, press [EXIT]
repeatedly to return to the PLAY screen.
Doubling
When you want to spread out the guitar backing sound
to the left and right, record the same guitar backing
separately to two tracks, then pan the sounds to the left
and right. This is known as "doubling."
By using the "DBLN" loop effect, you can produce a
doubling effect even from a single-track (mono)
recording, allowing you to make more efficient use of
the tracks.
* If you want to emphasize the doubling effect, pan the
track completely to the right or to the left and increase
the doubling effect level. In addition, use the following
procedure to raise the send level.
You cannot use the chorus, delay, and doubling effects
together. You must choose only one.
Loop effects do not have "patches."
Loop effect settings are saved along with the song data.
If you want to save the settings in the currently selected
song, hold down [STOP], and press [REC].