Erasing Data (Track Erase); Erasing By Specifying The Time (Tme/Mes) - Boss BR-600 Owner's Manual

Editing the Performance on a Track (Track Edit)
6
Press [ENTER].
fig.02-450
7
Use [CURSOR] and the TIME/VALUE dial to specify
the time of the beginning of the location "T" (To)
where you want the data to be moved.
8
When you are ready to execute the move, press
[ENTER].
The display will ask "Are you sure?," so that you can
confirm the operation.
9
Press [ENTER].
Move Event is executed.
10
Press [UTILITY] (or press [EXIT] repeatedly) to
return to the Play screen.
* During updating, "Keep power on!" appears in the upper
line of the display, while the lower line shows what is being
processed.
82

Erasing Data (Track Erase)

Track Erase allows you to erase a specific part of data. Even
if data exists after the specified part, it will not be moved
forward to fill the gap left by the erasure. Like a normal
tape recorder, erasing can be considered covering
unwanted data by recording emptiness.
Do not leave a portion of less than 1.0 seconds in length
after the erased portion. If a portion that short does
remain, it will end up being silent.
Erasing by specifying the
■
time (TME/MES)
Perform the procedure given below to erase the portion
between specific times.
fig.02-500
START
1
Confirm that [PAD] is not lit, then press [UTILITY].
2
Press CURSOR [
"TRK," and press [ENTER].
fig.02-510
END Time
] [ ] to move the cursor to