Error Message Listing - ABB ACH550 series User Manual

E-Clipse Bypass Configurations for ACH550 Drives
Error Messages
# Error Message
1 CAN'T EDIT
PAR IS READ ONLY
2 CAN'T EDIT
WHEN STARTED
3 CAN'T EDIT
UP+DOWN ONLY
4 CAN'T EDIT
INP VOLTAGE LOW
5 CAN'T EDIT
PAR IS HIDDEN
6 CAN'T EDIT
UNDER LO-LIMIT
7 CAN'T EDIT
UNDER HI-LIMIT
8 CAN'T EDIT
ENUM VAL ONLY
9 CAN'T EDIT
NO DEFAULT
10 CAN'T EDIT
TRY AGAIN.
Try to save value (=press the ENTER key in Parameter Edit State) of a read-
only parameter. E.g. try to change value PAR 01.02 INPUT VOLT
Try to change value of a parameter, which is allowed to be changed only when
system is not started. E.g. PAR 16.02 RUN ENABLE
Try to change value of a "reset only" parameter other than zero. UP+DOWN
buttons must be pressed simultaneoulsy for requesting default value of the
PAR on the display (value zero), and after that ENTER pressed for saving it
(reset the parameter). E.g. PAR 04.01 LAST FAULT
Input voltage too low. Changing of parameters prohibited since system cannot
save values to nv-mem w/ insufficient voltage
Try to save value (=press the ENTER key in Parameter Edit State) of a hidden
parameter. Should not be possible. If hidden parameters are turned visible, this
Try to save value which is over LO-LIMIT of the parameter. Should not be
possible when changing parameters from control panel.
Try to save value which is over HI-LIMIT of the parameter. Should not be
possible when changing parameters from control panel.
Try to save value which is out of enumerated value list. Should not be possible
when changing parameters from control panel.
Try to request default value (=press UP and DOWN buttons simultaneously)
for a parameter which is defined not to have a default value. Should not be
possible when changing parameters from control panel.
Parameter system is busy, e.g. application macro change is in process at the
same time when someone is trying to save a value for a parameter. Should not
be possible when changing parameters from control panel.
Description
message is not given
Diagnostics and Troubleshooting
85