E-Clipse Bypass Configurations for ACH550 Drives
Connection Diagrams – Standard E-Clipse Bypass (Wall Mounted)
ACH550 Standard E-Clipse Bypass units are configured for wiring access from the
top. The following figure shows the Standard E-Clipse Bypass (wall mounted) wiring
connection points. Refer to the ACH550-UH User's Manual for control connections
to the drive.
User Power
Cable Guides
E-Clipse Bypass
Control Board
Terminals X2
Service Switch
(Optional)
Motor
Terminals
Output Ground
Lug
Disconnect Switch
or Circuit Breaker
Input Power
Terminals
Input Ground
Lug(s)
B1
11
ACH550
Installation