D) Operation Command And Frequency Command; Operation Mode Selection - Mitsubishi Electric FR-CS84-012 Instruction Manual

5.5

(D) Operation command and frequency command

Purpose
To select the operation mode
To start up the inverter in Network operation
mode at power-ON
To select the command source during
communication operation
To prevent the motor from rotating
reversely
To perform JOG (inching) operation
To control the frequency with combinations
of terminals
5.5.1

Operation mode selection

Select the operation mode of the inverter.
The mode can be changed among operations using external signals (External operation), operation by the PU such as the
operation panel or parameter unit (PU operation), combined operation of PU operation and External operation (External/PU
combined operation), and Network operation.
Pr.
79
Operation mode selection 0
D000
The following table lists valid and invalid commands in each operation mode.
100
5. PARAMETERS
5.5 (D) Operation command and frequency command
Operation mode selection P.D000
Communication startup
mode selection
Operation and speed
command sources during
communication operation,
command source
selection
Reverse rotation
prevention selection
JOG operation
Multi-speed operation
Name Initial value
Parameter to set
P.D000, P.D001
P.D010, P.D011,
P.D013
P.D020
P.D200, P.F002
P.D301 to P.D315
Setting range
0 to 4 Select the operation mode.
Refer to
page
Pr.79 100
Pr.79, Pr.340 104
Pr.338, Pr.339, Pr.551 105
Pr.78 108
Pr.15, Pr.16 108
Pr.4 to Pr.6, Pr.24 to
109
Pr.27, Pr.232 to Pr.239
Description