Positioning Rear Centering Jaws For Left Hand Operation; Oil Line Set-Up For Left Hand Operation; Accessories - RIDGID 1822-I Operator's Manual

1822-I Pipe and Bolt Threading Machine
Figure 21 – Machine chucking system set up for let hand
operation (e-clips and retainers removed for
clarity)
NOTE! Rods must be rotated 180° to match square pins
of rods to locating slots in front jaws. Rear jaws
can be used to hold rods in position.
6. Reinstall washers and E-Clips on drive pins. Place the
spacers on rods and install retainer and E-Clips.
7. Proceed to rear jaws.
18
Positioning Rear Centering Jaws for
Left Hand Operation
(Figure 21)
1. Rear centering jaws will be pointing outward after
front jaw reversal to left hand operation.
2. Remove three E-Clips holding the rear retainer in
place and remove retainer.
3. Remove spacers and rear jaws.
4. Reverse rear jaws and reinstall on square pin or
rods.
5. Reinstall spacers, rear retainer and retaining clips.
NOTE! Before reinstalling machine covers make sure
both front and rear jaws are in the same oper-
ating mode. (See Figure 21 for L.H. set up or
Figure 24 if returning to R.H. operation.)

Oil Line Set-Up for Left Hand Operation

1. For left hand operation the oil supply line to the car-
riage connects to the oil pump fitting marked IN.
2. For left hand operation, the oil supply line from the oil
filter connects to the oil pump fitting marked OUT.
NOTE! For right hand operation oil lines are reversed
from the positions described above.
WARNING
switch positions are reversed. CLOSE becomes OPEN.
OPEN becomes CLOSE.

Accessories

Only the following RIDGID products have been designed
to function with the 1822-I Threading Machine. Other
accessories designed for use with other tools may be-
come hazardous when used on this Threading Machine.
To prevent serious injury, use only the accessories listed
below.
Accessories For Threading Machine
Stands:
No. 1406......................Folding Wheel Stand with
No. 100A .....................4 legs w/tray
No. 150A .....................2 wheels w/tray
No. 200A .....................2 wheels w/enclosed cabinet
Ridge Tool Company
In the left hand operating mode, the control
WARNING
No. 1460 Oil Pan Cover