Interlogix ZeroWire User Manual page 4

If your service provider has enabled the quick arm feature, you can simply touch the Away
key:
4.
5.
6.
Forced Arming Feature
Normally all zones must be secure before you can arm your security system.
For example, a home with a door detector on the front door. When forced arming is NOT
enabled, you would have to close the door to secure the sensor before being allowed to
arm the system. When force arming is enabled, you can arm your system with the door
opened, and the door will automatically be protected after it is fully closed as you leave.
If your service provider has enabled the "forced arming" feature, you will be able to arm
your security system even if pre-selected zones are not secure. The Ready Light will flash
green to indicate this feature is available. Press Status key to hear which zones are not
secure.
Check with your installer to confirm how Forced Arming has been set up for your
system:
Option 1: At the end of the exit delay, zones that are not secured will automatically be
bypassed. If they later become secured, the bypass will be automatically removed and
they will become part of the active security system until the system is disarmed.
Option 2: At the end of the exit delay:
• delay sensor types that are not secured will start an entry delay and go into alarm if a
valid PIN code is not entered,
• instant sensor types that are not secured will go into alarm immediately.
Explanation of Stay Modes
Use one of the Stay Modes when you are staying inside the premises and you want the
perimeter protected. You will be able to move around inside the protected area without
setting the alarm off. This gives you peace of mind even when you are at home.
For example, Stay Mode is often used at night. Internal motion sensors will be ignored.
Perimeter detectors will be armed and active to detect intruders. The security of your home
in Stay mode is dependent on the type and number of detectors you have installed and are
active in Stay mode.
There are three similar modes available - Stay Mode, Stay Instant Mode, and Night Mode.
ZeroWire User Manual
READY STATUS
AWAY
EXIT DELAY BEEPS
Check ready key is green.
Check status key is green.
Select the Away Mode.
Leave the premises.
13