6. Login - Enter your username and password, by default this is "installer" and 9713.
7. You should now see a screen similar to the one shown below:
Connecting over Wired LAN
1. Connect power to your ZeroWire.
2. If this ZeroWire was previously connected via WiFi, switch connection mode to switch
to Ethernet by pressing Menu, 9, Master PIN, 7. Press 7 again if it announces "WiFi is
on". The ZeroWire will announce "Ethernet is on" when this is set correctly. Press
Menu, Menu to exit.
3. Connect an Ethernet cable to the rear of the ZeroWire and wait 10 sec for the local
router to assign the ZeroWire an IP address
4. On the ZeroWire press Menu, 8, [Master PIN], 6 and note the IP address announced. If
you hear "IP address is not configured" then wait a further 30 s and repeat this step.
5. Open your web browser
36
installer
9713
ZeroWire User Manual